時計ブランド用ヒンジボックス

Watch Brand Hinged Box started from a single constraint: the watch had to present at a fixed angle the moment the lid opened, with the certificate stored but visible. The failure mode we had to design out first was the watch shifting out of its presentation angle — everything else in the specification follows from that.

Structure

We resolved it with a hinged rigid box, sized to the actual contents rather than to a stock die-line. A ribbon-secured holder holds each piece at a fixed position, so the pack arrives square and opens the same way every time.

Materials

Textured specialty paper carries the load. Board grade and wall thickness are matched to the weight and fragility of the contents, so the box survives palletised freight without corner crush or lid bow.

Printing and finishing

Branding is applied with a metal nameplate and finished with edge-to-edge soft-touch lamination. Colour runs to CMYK, with Pantone spot matching for brand-critical marks and a printed proof before the run.

Quality control

Each run is checked against the approved sample: dimensions, insert fit, colour density and finish adhesion. Drop and stack tests are available for export shipments.

Applying this to your project

Rolled out across three collections, with tooling amortised over repeat runs. Die-line, insert tooling and board spec are kept on file, so repeat runs need no re-tooling. Send us product dimensions and target quantity for a quote against this structure.